Welcome to the official website of Foshan Weilin Qinli Machinery Co., Ltd.!

Production and sales of dock levelers and unloading platforms
Manufacturers from Guangdong Province, China

Foshan Weilin Qinli Machinery Co., Ltd.

WeChat scan

Service Hotline:

+8613929964509
Current position : Home > News Center > Products information

Service Hotline

+8613929964509

Contact person : Miss Zhou
Cell phone : +8613929964509
E-Mail : weilinqinli168@163.com
Address : No. 5, First Street, Niulanwei Road, Dafengtian, Wuzhuang, Luocun, Shishan Town, Nanhai District, Foshan City, Guangdong Province, China

Daily maintenance of scissor lift platform

Release time:11-29Views:311

Scissor lift platform maintenance


1. Whether the functions of the scissor lift platform are normal, such as emergency stop, horn, brake and safety alarm device, etc.;


2. Pay attention to check and replace the hydraulic oil and filter.


3. Whether all important structural parts are normal, such as whether there are damages, loose bolts or missing parts; whether the rim tires, sliders, fork mounting bearings, etc. are damaged;


4. For storage batteries, check regularly and add distilled water (usually only water is reduced, but whether to add water or electrolyte, the specific gravity of electrolyte should be measured with an instrument). At the same time, pay attention to reasonable charging and discharging, fasten the terminals, and apply petroleum jelly to prevent corrosion.


Scissor lift platform


Methods of Extending the Life of Scissor Lifting Platform


When using a scissor lift platform, because the equipment is equipped with an electric motor, it is also necessary to check for overheating. If the motor overheats, it may damage the motor. The cost of replacing the electric motor is higher, so it is driving. Or during trial operation, if the motor is overheated, stop the operation immediately, and then check and eliminate the fault that caused the motor to overheat so that the machine can continue to be used. There will be brushes in the machine, and the parts where the brushes touch each other must be kept clean.


The bearings in the scissor lift platform also need to be checked regularly. Especially the bearings must be added with butter regularly. If the butter is not enough, it will cause severe wear when the bearing is running, which will affect the service life of the machine. There will be various wires and cables inside the machine.


After a period of use, the wires and cables need to be checked. If the wires and cables are found to be damaged, they must be repaired or replaced. You should also regularly check whether the screws at this connection are loose. If you find that the screws are loose, you should tighten the screws. Some screws must meet certain torque requirements. If there is no relevant professional equipment, you can use professional equipment in the repair shop. To tighten the screws, the screws must meet the corresponding torque requirements.


Share this:
Whatsapp
Service Hotline

Service Hotline

+8613929964509

WeChat
weilinqinli
Back
to top